Using the Design View

You can use the Design view to edit messages without writing HTML code. The Design view automatically corrects errors in your code and lets you format text using toolbar buttons similar to those in standard word processors.

If you want more control over your HTML code, for example to avoid automatic code correction, you can disable the Design view for a message and edit the message using the Code view.

If you disable the Design view, it will not be available for the message until you re-enable it. If you leave it enabled, you can switch between the Design view and Code view when editing the message.

To disable or enable the Design view

1. On the Navigation bar, click Email Marketing then Messages.

The Messages page opens, displaying a list of all existing messages.

Tip: You can filter the list to display only specific messages.

2. Point to the message you want and click Edit.

The Edit Message page opens.

3. Click 2. Edit Message at the top of the page.

The Edit Message page opens.

4. Do one of the following:

• To disable the Design view, select the Disable Design View checkbox.
• To enable the Design view, clear the Disable Design View checkbox.

To use the Design view

• If the Design view is enabled for the message, it automatically opens when you open the Edit Message page.

Or

• If you are using the Code view, click on the Edit Message page.

Tip: If is not enabled, the Design view is disabled for this message. To enable it, clear the Disable Design View checkbox.